Difference between revisions of "EMCON"

From Weapons Release Wiki
Jump to: navigation, search
Line 41: Line 41:
  
 
[[File:Command 2018-04-03 09-57-38.png|frame|none]]
 
[[File:Command 2018-04-03 09-57-38.png|frame|none]]
 +
 +
----

Revision as of 14:54, 3 April 2018

Emissions control is a huge part of your doctrine. Deciding when the turn your active sensors on, for which units, can make a massive difference. As with the other doctrines you can set EMCON for the entire side, groups, missions, or individual units. There are multiple places in the interface that one can set EMCON. First we will cover the EMCON Window (CTL+F9).

Note : Passive sensors are always receiving data and these settings do not turn them on or off.

Command 2018-04-03 09-24-29.png
  • Inherit from Parent

This options is not available to the side level. For units, groups, and missions, by checking this the units will follow the side EMCON. Any change made at the parent level will be immediately reflected at the units beneath. If this is checked you will be unable to set EMCON for this unit, group, or mission.

Uncheck the box and you can change the EMCON.

    • Passive : If the unit has an emitting radar it will not turn it on. Unit will still receive radar signals if equipped with the proper passive sensor.
    • Active : Unit will turn on emitting radar.

If the unit has a damaged radar it will not emit even if set to Active. Going radar active can give you a much better combat picture but also makes your unit potentially visible, or more visible, than it was prior to going active.

    • Passive : If the unit is equipped with OECM it will not turn it on.
    • Active : The unit will turn on the OECM suite and attempt to jam hostile radars.
    • Passive : If the unit has an emitting sonar it will not turn it on. Unit will still receive sonar if equipped with a proper passive sensor.
    • Active : Unit will turn on the sonar system.

The submarine tutorials deal with this but, as a sub, it can be very dangerous to turn on your sonar. Hostile units, from very far away, can pinpoint your location without you being able to detect them with your sonar.

It's worth noting that certain mission types allow the unit to remain passive until it is in the mission zone. At which point the unit would go active, if the EMCON is set active.


The EMCON screen is available via the Mission interface where you can set the Mission Doctrine and Escort Doctrine. You may also select individual units, multiple units, or a group and press CTL+F9 to bring up the Doctrine menu for that group or units.

Command 2018-04-03 09-55-38.png
Command 2018-04-03 09-56-32.png
Command 2018-04-03 09-57-38.png